If this document does not correspond to your current software version, you can go to Download Center to find other available document versions.

QNAP

QuTS hero 5.0.x

Download (PDF)

SnapSync Job Actions

You can perform various SnapSync job actions by going to Storage & Snapshots > Snapshot Backup > SnapSync. Identify a job and select an action under the "Data Status" or "Action" column headers.

Icon

Action

Description

Run now

Run the job immediately.

Stop

Stop a running job.

Edit

Edit the job's settings.

You can edit backup frequency, network adapter, and certain job options.

Note:

  • You cannot change the job's backup frequency from Scheduled or Manual to Real-Time, or from Real-time to Scheduled or Manual.

  • If the destination login account password changes, then the job will stop working. To resolve this issue, edit the job setting on the source NAS and then update the destination password.

  • If the destination IP address changes, then the job state will change to Disconnected. To resolve this issue, edit the job setting on the source NAS and then update the destination address.

Delete

Delete the job.

Suspend job

Temporarily prevent a job from running as scheduled.

Resume job

Allow a previously suspended job to run as scheduled. If QuTS hero detects that the source and destination folders are different, then it immediately runs the job and synchronizes them.

Latency Monitor

Configure the latency threshold. If the job latency goes over the threshold six times within a minute, QuTS hero issues a warning notification.

This action is only available for real-time jobs.