If this document does not correspond to your current software version, you can go to Download Center to find other available document versions.

QNAP

QNE Network 1.0.x

Download (PDF)

Removing HA Configuration

To replace a node device, you must first remove the HA configuration.

You can initiate HA configuration removal from either node device.

Note:

If you only want to reconfigure a device or perform device maintenance, QNAP recommends shutting down the device without removing the HA configuration. For details, see Shutting Down Node Devices.

  1. Log on to QNE on the active or standby node.
  2. Open HA Manager.
  3. Go to HA Settings > HA Maintenance.
  4. Click Remove HA Configuration.

    The Remove HA Configuration screen appears.

  5. Select one of the following:
    • Reset network settings on standby node “[HOSTNAME]”
    • Reinitialize standby node “[HOSTNAME]”
      Warning:

      Reinitializing the standby node will delete all existing data on the node.

  6. Enter the password for the standby node device.
  7. Select the checkbox to acknowledge the warning.
  8. Click OK.

HA Manager removes the HA configuration between the node devices.