If this document does not correspond to your current software version, you can go to Download Center to find other available document versions.

QNAP

QuTS hero h6.0.x

Download (PDF)

Virtual switch configuration

The Virtual Switch screen controls the configuration and management of virtual switches running on the NAS. Virtual Switches allow physical interfaces and virtual adapters to communicate with each other.

Important:

If you set a virtual switch as the cluster interface in High Availability Manager, the cluster IP (CIP) is automatically displayed in Network & Virtual Switch. When a CIP is present, you cannot change any IPv4 network settings. You can only modify the IPv6 settings, and the virtual switch cannot be deleted.

QuTS hero supports three different virtual switch modes .

Mode

Description

Basic

This mode is well-suited for most users, and requires minimal configuration of network settings.

Advanced

This mode is best-suited for power-users who need more control over the configuration of network settings.

Software-Defined Switch

This mode is suited for power-users who need to simulate an L2 physical switch.

Important:

Packet forwarding rates are limited when using this mode.

Tip:

To access this page, Network & Virtual Switch must be operating in Advanced Mode.