If this document does not correspond to your current software version, you can go to Download Center to find other available document versions.

QNAP

QuTS hero h5.2.x

Download (PDF)

Configuring RADVD server settings

This RADVD screen controls the creation and management of Router Advertisement Daemon (RADVD) servers. This service sends messages required for IPv6 stateless auto-configuration. This service periodically sends router advertisement (RA) messages to devices on the local network, and can also send a router solicitation messages when requested from a connected node.

  1. Log on to QuTS hero as administrator.
  2. Go to Control Panel > Network & File Services > Network & Virtual Switch.

    The Network & Virtual Switch window opens.

  3. Go to Network > DHCP Server.
  4. Go to the RADVD tab.
  5. Click Add.

    The RADVD - Outgoing Interface window opens.

  6. Select the outgoing interface.
  7. Click Next.
  8. Configure a static IP address for the adapter.
    Important:

    A static IP address must be configured when creating a RADVD server.

    1. Click Yes.
    2. Optional: Configure the static IP address settings.
      1. Specify a fixed IP address.

        Tip:

        Examine your network setup for guidance on how to best configure these settings.

      2. Specify the subnet mask used to subdivide your IP address.

      3. Specify the prefix length for the adapter.

        Tip:

        Obtain the prefix and the prefix length information from your ISP.

      4. Specify the IP address of the default gateway for the adapter.

      5. Specify a jumbo frame size.

        Important:
        • Jumbo Frames are only supported by certain NAS models.

        • Using Jumbo Frames requires a network speed of 1000 Mbps or faster. All connected network devices must enable Jumbo Frames and use the same MTU size.

      6. Specify the speed at which the adapter will operate.

        Tip:

        Auto-negotiation will automatically detect and set the transfer rate.

      7. Assign an IP address for the primary DNS server.

      8. Assign an IP address for the secondary DNS server.

        Important:

        QNAP recommends specifying at least one DNS server to allow URL lookups.

    3. Click Next.
  9. Select a second adapter for the RADVD service interface.
  10. Click Next.
  11. Optional: Configure a static IP address for the second RADVD adapter.
    Important:

    Creating an RADVD interface requires that the adapter use a static IP address. If the adapter already uses a static IP address, skip this step.

    1. Click Yes.
    2. Configure the static IP address settings.
    3. Click Apply.
  12. Configure the RADVD server settings.
    1. Specify the routing prefix for the adapter.
      Tip:

      Examine your network setup for guidance on how to best configure these settings.

    2. Specify the prefix length for the adapter.
    3. Specify the length of time that an IP address is reserved for a DHCP client.

      The IP address is made available to other clients when the lease expires.

    4. Specify the DNS server address.
    5. Optional: Specify a secondary DNS server.
      Important:

      QNAP recommends specifying at least one DNS server to allow URL lookups.

  13. Click Apply.

Network & Virtual Switch adds the RADVD server.