Configuring RADVD server settings
This RADVD screen controls the creation and management of Router Advertisement Daemon (RADVD) servers. This service sends messages required for IPv6 stateless auto-configuration. This service periodically sends router advertisement (RA) messages to devices on the local network, and can also send a router solicitation messages when requested from a connected node.
- Log on to QTS as administrator.
-
Go to Control
Panel > Network & File
Services > Network &
Virtual Switch.
The Network & Virtual Switch window opens.
- Go to Network > DHCP Server.
- Go to the RADVD tab.
-
Click Add.
The RADVD - Outgoing Interface window opens.
- Select the outgoing interface.
- Click Next.
-
Configure a static IP address
for the adapter.
Important:
A static IP address must be configured when creating a RADVD server.
- Click Yes.
- Optional:
Configure the static IP
address settings.
-
Specify a fixed IP address.
Tip:Examine your network setup for guidance on how to best configure these settings.
-
Specify the subnet mask used to subdivide your IP address.
-
Specify the prefix length for the adapter.
Tip:Obtain the prefix and the prefix length information from your ISP.
-
Specify the IP address of the default gateway for the adapter.
-
Specify a jumbo frame size.
Important:-
Jumbo Frames are only supported by certain NAS models.
-
Using Jumbo Frames requires a network speed of 1000 Mbps or faster. All connected network devices must enable Jumbo Frames and use the same MTU size.
-
-
Specify the speed at which the adapter will operate.
Tip:Auto-negotiation will automatically detect and set the transfer rate.
-
Assign an IP address for the primary DNS server.
-
Assign an IP address for the secondary DNS server.
Important:QNAP recommends specifying at least one DNS server to allow URL lookups.
-
- Click Next.
- Select a second adapter for the RADVD service interface.
- Click Next.
- Optional:
Configure a static IP address
for the second RADVD adapter.
Important:
Creating an RADVD interface requires that the adapter use a static IP address. If the adapter already uses a static IP address, skip this step.
- Click Yes.
-
Configure the static IP
address settings.
- Click Apply.
-
Configure the RADVD server
settings.
-
Specify the routing prefix for the adapter.
Tip:
Examine your network setup for guidance on how to best configure these settings.
- Specify the prefix length for the adapter.
-
Specify the length of time that an IP address is reserved for a DHCP
client.
The IP address is made available to other clients when the lease expires.
- Specify the DNS server address.
- Optional:
Specify a secondary DNS
server.
Important:
QNAP recommends specifying at least one DNS server to allow URL lookups.
-
Specify the routing prefix for the adapter.
- Click Apply.
Network & Virtual Switch adds the RADVD server.