Configuring the RTRR Server

  1. Open HBS 3.
  2. Go to Services > RTRR Server.
  3. Configure account access settings.

    Option

    Description

    Shared RTRR server account

    This option allows incoming connections to log in with a shared account.

    • Password: Specify a password.

    • Verify password: Verify the password.

    Note:

    The password must contain 1 to 32 characters with the following conditions:

    • Valid characters: A–Z, a–z, 0–9, space ( )

    • Valid special characters: . - _ ~ ! @ # $ % ^ & ( ) { }

    • Does not start or end with a space ( )

    Local NAS accounts

    This option allows incoming connections to log in with a local NAS account.
  4. Configure RTRR server settings.

    Setting

    Description

    Port

    Specifies the port number used to access the local NAS.

    Use TCP BBR congestion control

    This option optimizes transmissions speeds allowing for higher bandwidth and lower latency.

    Integrate with QuWAN

    Allows QuWAN to manage and optimize network traffic for jobs using this service.

    Upload limit

    Sets the upload rate limit.

    • Unlimited: No limit is set.

    • Maximum: Specifies a maximum limit.

    Download limit

    Sets the download rate limit.

    • Unlimited: No limit is set.

    • Maximum: Specifies a maximum limit.
  5. Optional: Configure network access approval.
    1. Select Allow approved connections.
      Note:

      If no IP addresses are added, all connections are allowed.

      The Approved Connections table appears.
    2. Click Add.

      The Add IP Address window opens.

    3. Select an IP address version.
    4. Specify an IP address, or IP address and subnet mask.
    5. Select an access privilege.
    6. Click Add.
  6. Click Apply.

HBS 3 saves the RTRR server configuration.

Parent topic: RTRR Server